Cleaning And Maintenance - Velleman VDLPROM9 Manual Del Usuario

• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
d) Mounting the Mirror Ball and Motor
• The mirror ball motor can be used upright, standing on a floor or table, or ceiling-mounted.
• The carrying construction must be able to support 10 kg for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
• Make sure the rotation of the mirror ball is never slowed down or stopped. Make sure no side
forces can impact on the carrying construction.
1. Unscrew the lower screw.
2. Fix the mirror ball onto the motor axle by means of the screw. Make sure the holes of the
mirror ball axle and those of the motor axle match.
3. Use the built-in suspension hook if you wish to hang the mirror ball motor.
5. Use
After connecting the devices to the mains, the mirror ball will start to rotate at 3 RPM and the light
will switched on. Aim the light on the mirror ball to obtain a beautiful and colourful effect.
The strobe will start flashing at a steady pace. Increase or decrease the flash rate by means of the
rotary button on the back of the strobe.
6.

Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with e.g. do not drill extra
holes in mounting supports, do not change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician
maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts.
8. Contact your dealer for spare parts if necessary.
VDLPROM9 4
®
VELLEMAN