Service Position - Ariens Max Zoom Manual Del Operador

Period Service Task
Each Follow Engine Manual Perform scheduled engine maintenance. Refer to
Maintenance Schedule engine manual for detailed instructions.
Use
Every Check Mower Blades Check mower blades for wear. Sharpen or replace
25 as needed. See Mower Blades on page 20.
Hours
Check Air Filter Check air filter for dirt. Clean as required. Follow
Engine Manual for maintenance schedule.
Every
50 Lubricate Unit Oil all pivot points and pin connections. Grease
lube fittings. See Lubricate Unff on page 22.
Hours
Check Brake Gap Adjust gap if necessary. See Adjusting the Parking
Brake on page 24.
Clean Battery Keep battery and its terminals clean. See Clean
Batteryon page 21.
Every Check Fasteners Check mower blade mounting hardware and all
other fasteners. Replace missing or damaged
100 fasteners. Tighten all nuts and bolts to their correct
Hours torque value.
Check Belts Replace worn or deteriorated belts. See Replacing
Mower Belts on page 25 and Replacing the Hydro
Pump Belt on page 26.
Every Change Hydraulic Fluid Drain hydraulic fluid tank, replace hydraulic oil filter,
400 and Filter* refill system. See Hydraulic Fluid on page 19.
Hours
*Change hydraulic fluid and filter after the first 75 hours of operation and then
every 400 hours.
Ariens Dealers will provide any service which
may be required to keep your unit operating at
peak efficiency. Should engine service be
required, it can be obtained from a Ariens
Dealer or the engine manufacturer's
authorized service center.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
,_ CAUTION: HOT SURFACES
may result in injury. DO NOT
touch engine or drive parts which
are hot from operation. Allow
parts to cool before servicing.
SERVICE POSITION
1. Place unit on a flat level surface.
ALWAYS stop engine. Ensure unit is
secure and will not tip over. Strap and
clamp onto lift if used.
2. Place steering levers in neutral and
engage parking brake.
3. Remove wing knob.
4. Tip seat forward (Figure 6).
_1 AUTION: Be sure footing is
secure to accomodate weight
shift of seat when rotating it into
service position.
5. When service is complete, lower seat
and secure with wing knob or hex nut.
GB - 18