Toreverse - Ariens Max Zoom Manual Del Operador

4.Start the engine, run engine atfull
throttle, and release the parking brake.
5.Move t he steering levers from Forward
toReverse several times tomake s ure
controls are free. Then r eturn steering
levers toneutral position.
6.Check wheel(s) formovement.
NOTE: The right and left h ydraulic pumps are
adjusted the same w ay.
7.Ifawheel moves, adjust the return to
neutral mechanism onthe hydraulic
pump:
a. Loosen the return toneutral screw
onthe pump.
b. Slowly move the speed and
direction control bracket clockwise
orcounterclockwise until the
wheel stops moving.
c. Hold t he stop b racket inposition
and tighten the return toneutral
screw o nthe pump.
8.Move s teering levers from Forward to
Reverse several times and return
steering levers toneutral position.
Check wheel(s) formovement.
9.Ifwheel isstill m oving, repeat steps 7
and 8.
10. S hut OFF engine.
11. Replace drive w heels.
Axle Direction
Return toNeutral
Adjusting Screw
Speed and
Direction
Control Arm
Figure 13
Aligning the Steering Levers
(Figure 14)
1. Shut OFF engine. Engage parking
brake. Remove the ignition key.
2. Place seat in the service position (See
Service Position on page 18).
3. Loosen brake interlock on the same side
as steering lever to be adjusted.
4. Loosen tie rod jam nuts and turn tie rod
until steering levers are aligned.
5. Tighten jam nut on tie rod, tighten brake
interlock.
1. Tie-Rod Jam 4. Brake
Nut Interlock
2. Tie-Rod 5. Hydrostatic
3. Steering Transmission
Lever
Figure 14 OF3381
GB - 23