Specifications - Samson XM410 Manual Del Usuario

Specifications

Specifications
Rated Output power
Frequency response
Total Harmonic Distortion
HUM & Noise
(Average, RS+150Ω)
(with 22Hz~22KHz BPF)
Maximum Voltage Gain
Crosstalk 1KHz
Input Channel Equalization
Meters
Graphic Equalizer
Internal DSP Effects
Phantom Power
CLIP Indicators
Foot Switch
GENERAL
Power Requirement
Power Consumption
Weight
Dimensions
200W/4Ω per amplifier
20Hz~20KHz+/-0.5dB@1W Output into 8Ω (AMP OUT)
20 Hz~20KHz+/-0.4@+4dB Output into 10kΩ (MAIN OUT,
MONITOR OUT, AUX 2 SEND)
Less than 0.06%@20Hz~20KHz, 75W output into4Ω (AMP OUT)
Less than 0.1%@20 Hz~20KHz+14dB output into 10KΩ
(MAIN OUT, MON OUT, AUX 2 SEND) + 4dB
-121dB equivalent input noise
-100dB residual output noise (MAIN OUT, MONITOR OUT, AUX 2
OUT)
-79dB (MAIN OUT, MONITOR OUT) Master level control at maxi-
mum all channel level control at minimum.
-79dB (AUX 2) Master level control at maximum all channel level
controls at minimum
67dB CH IN (MIC) to AMP OUT
48dB CH IN (MIC) to MAIN OUT, MONITOR OUT
54dB CH IN (MIC) to AUX 2 OUT
30dB CH IN (MIC) to REC OUT
32dB CH IN (LINE) to MAIN OUT, MONITOR OUT
26dB AUX IN to MAIN OUT
24dB TAPE IN to MAIN OUT
70dB adjacent input, 70dB input to output
HIGH
MID
LOW
7 POINT LED METERS (-20, -10, -7, -4, 0, +3, +6dB)
7 bands (63, 160, 400, 1K, 2.5K, 6.4K, 16KHz)
24 BIT - 10 Presets each: 1 - Performance; 2 - Hall Reverb, 3 - Plate
Reverb; 4 - Spring Reverb; 5 - Echo; 6 - Flange + Verb; 7 -
Chorus + Verb; 8 - Echo + Verb; 9- Chorus; 10- Flange
+48V
Turn on: THD> 0.1%
DIGITAL EFFECT MUTE: ON/OFF
110V-240V, 50/60Hz
100 W 1/8 power, 800W full
40 lbs./18.2Kg
21" (W) x 14" (H) x 13-3/4" (D)
534mm(W) x 356mm(H) x 350mm(D)
Specifications subject to change without notice
82
12KHz shelving (+/- 15dB Maximum)
2.5KHz peaking (+/- 12dB Maximum)
80Hz shelving (+/- 15dB Maximum)