Before You Start - Bresser National Geographic 9070100 Instrucciones De Uso

Remote sensor (Fig. 3)
1@
Display
Outdoor temperature, humidity, transmission channel
1# Battery compartment
1$
CH switch
Select a channel (1-3).
1%
Wall mount hole
This hole makes it possible to mount the remote sensor on a wall.
1^ °C/°F button
This button selects between Celsius (°C) and Fahrenheit (°F).
1&
Table stand
Foldable. Use this stand to place the device on a flat surface.
24

BEFORE YOU START

IMPORTANT!
1. Insert batteries for the main unit before start operation of the remote
sensors.
2. Place the main unit as close as possible to the remote unit.
3. Position the remote unit and main unit within the effective transmis-
sion range.
When changing batteries always change batteries in the main unit as well
as all remote units and replace them in the correct order, so the remote
connection can be re-established. If batteries are exchanged in only one
of the devices (i.e. the remote sensor) the signal can't be received or
can't be received correctly.
Note, that the effective range is vastly affected by building materials and
position of the main and remote units. Due to external influences (various
RC devices and other sources of interference), the maximum distance
can be greatly reduced. In such cases we suggest to position the main
unit and the remote sensor at other places. Sometimes all it takes is a
relocation of one of these components of a few inches!
Though the remote unit is weather proof, it should be placed away from
direct sunlight, rain or snow.