Brave VH9922 Manual Del Propietario E Instrucciones De Seguridad página 8

Assembly Instructions
9. Put one foot on the base plate of the front
leg to prevent the log splitter from tipping
up and lower the rail to a horizontal
position.
NOTE: Block the wheels to prevent the base
unit from moving.
10. Insert the hitch pin through the top, front
hole of the hinge plates, through the rail
and secure it with a hair pin clip on the
opposite side.
11. Link the ends of safety chains together
with the safety quick-link and tighten the
link's locknut securely with a wrench.
12. Place the hitch over the attachment tube,
aligning the bolt holes, and insert the rear
1/2 x 3 inch bolt (A). Install and tighten
the locknut.
Insert the end of quick link into front tube
of the rail assembly and insert a 1/2 x 3
inch bolt (B) through link and hitch.
Install and tighten the locknut.
Brave Products, Inc. 800-350-8739
12
13. Install the valve link, onto the valve body,
as shown using a 1/4 x 1 inch long clevis
pin. Secure the clevis pin with a cotter
pin (bend the ends of the cotter pin to
make it secure).
14. Install the valve handle onto the valve link
using a 1/4 x 3/4 inch long clevis pin.
Secure the clevis pin with a cotter pin
(bend the ends of the cotter pin to make
it secure).
15. Attach the valve handle to the valve spool
using a 1/4 x 1 inch long clevis pin.
Secure the clevis pin with a cotter pin
(bend the ends of the cotter pin to make
it secure). Attach the knob to the valve
handle, if necessary.
16. Attach high-pressure hose (A) to the bot-
tom valve fitting.
NOTE: The high-pressure hose is self-seal-
ing and does not require any type of sealing
material. Tighten the fitting with the 10 inch
crescent wrench.
800-350-8739
Assembly Instructions
Brave Products, Inc.
13