Cleaning And Maintenance - Marta MT-1963 Manual De Instrucciones

Pour liquid into the pot (no more than maximum on the scale). Press button «Подогрев/Отмена» and cooking process will start. Follow our below instructions:
- 500 ml / 1 hour 5 minutes
- 1000 ml / 1 hour 10 minutes
- 1500 ml / 1 hour 15 minutes
To stop or cancel the process press the button «Подогрев/Отмена». When pasteurization is over cool the product and save in cool place.
JAM
Please use program «Томление» (Slow stew) for cooking jam. Program works with no pressure (pressure limiting valve should be open). Place all ingredients into the pot according to a recipe. Close the lid.
Set pressure limiting valve into position «ОТКРЫТО» (Open). Press the button «Томление» (Slow stew). Set required time using buttons «+» and «-». Cook till the end of program.
STERILIZATION
There are two ways of sterilization using our multicooker: immersed and steamed.
Please use immersed way for jars and big objects:
Fill the jars with water and place them into the pot. Pour water into the pot to reach jars necks. Close the lid. Set pressure limiting valve into position «ЗАКРЫТО» (Closed). Press button «Пароварка» (Steam)
and set the time 10 minutes. Sterilize till the end of program. Set pressure limiting valve into position «ОТКРЫТО» (Open).
Use steamed way for small objects:
Place objects on the steamer. Pour 500 ml of water into the pot. Place steamer into the multicooker. Close the lid. Set pressure limiting valve into position «ЗАКРЫТО» (Closed). Press button «Пароварка»
(Steam) and set time 10 minutes. Sterilize till the end of program. Set pressure limiting valve into position «ОТКРЫТО» (Open).
TROUBLESHOOTING
Case
The lid is not closed well
The lid is not opened well
Steam is going from under the lid while
cooking
Float valve is in low position while cooking
Display shows E1
Display shows E2
Display shows E3
Display shows E4

CLEANING AND MAINTENANCE

 Before cleaning, always unplug the appliance.
 Let appliance cool down completely.
Cause
Sealed circle is not set properly
Float valve is block in high position
Float valve is not in low position
There is no sealed circle in the lid
The sealed circle is dirty
The sealed circle is damaged
The lid is not closed well
There is no enough products or water inside the pot
Pressure limiting valve is not in position ―ЗАКРЫТО‖
Sealed circle of float valve is damaged
System error
Short circuit
Overheat
Pressure sensor error
Check if the sealed circle is set properly
Make float valve free from strange objects which blocked it
If pressure limiting valve is set in position «ОТКРЫТО» and there is no
outgoing steam, but float valve is not in low position, then press it slightly
with wooden stick
Insert the sealed circle into the lid
Clean the sealed circle
Contact service center
Close the lid according to the article ―Using a multicooker‖
Add products and/or water
Set pressure limiting valve into position «ЗАКРЫТО» (closed).
Clean the sealed circle of float valve or contact service center
Unplug the appliance, let it cool down. Close the lid. If problem still exists,
contact authorized service center.
26
Solution