Warning!
Drain the fuel only in an appropriate container and
in a well-ventilated area, away from any source of
heat or fire. Let the engine cool down.
Warning!
Never store the tractor or fuel in enclosed places
where there is fire, sparks, water heaters, furnaces,
tumble driers or other gas applications or sources
of heat.
To store the tractor for long periods of time, wash the
equipment, remove the battery cable, and spray it with
a thin layer of oil to protect it from corrosion.
Front wheel convergence/shifting
These two adjustments are made to your tractor
still at the factory, with normal values. You cannot
adjust the convergence and shifting of the front
wheels of your tractor. If any damage affects these
settings, get in touch with the nearest TRAPP
Authorized Service Center.
How to remove the wheels for repair
1. Lock the shaft securely;
2. Remove the axle cover, retainer ring, counter-pin
and washers so that the wheels can be removed
(the rear wheels have a square key and hex bolt,
be careful not to lose them, as shown in Image 30);
3. Repair and reinstall the tire;
Note:
Only in the case of the rear wheels, align the
grooves in the wheel hub and axle; then insert the
square key.
150
4. Replace the washers and secure the retainer ring
securely into the shaft groove. For the front wheels,
put a new one against the pin, and for the rear ones,
tightly tighten the hexagonal bolt;
5. Reinstall the shaft cover.
Note:
To seal off holes in tires and to avoid low tires
due to small air leaks, you can use tire sealant
purchased from your nearest dealer. The sealant
can also prevent dryness and corrosion of the tires.
Harness
Pine
cutter
Shaft
cover
Image 30
Starting the engine with low battery
Warning!
Lead-acid batteries release explosive gases.
Therefore, they should be kept away from sparks,
flames and burning materials. Always wear eye
protection when handling these batteries.
If your battery is too low to start the engine, it must
be recharged (see "Battery").
www.trapp.com.br
Key (rear wheels)