Replacing The Headlight Bulb; Interlocking And Relays; Replacing The Fuse; Removing The Hood And Grill Assembly - TRAPP LT4217 Manual De Instrucciones

Replacing the headlight bulb

1. Lift the hood;
2. Pull the lamp socket out of its hole in the back of
the grill;
3. Replace the bulb in the socket and push it back
into the hole in the back of the grill;
4. Close the hood.

Interlocking and relays

Loose or damaged wiring may cause the tractor to
perform poorly, stop operating or fail to start.
Check the wiring.
 

Replacing the fuse

Replace the blown fuse with another 20 A
automotive fuse of the plug-in type. The fuse
holder is located next to the battery. To access the
fuse, remove the battery.
Removing the hood and grill
assembly
1. Lift the hood;
2. Disconnect
connector;
3. Stand facing the tractor and hold the hood by its
sides; Tilt it toward the engine and remove it from
the tractor.
When reinstalling the hood, be sure to
 
reconnect the headlamp wiring connector.
152
the headlight wiring
Hood
Connector of
headlight wiring

Engine

To adjust the throttle cable

The throttle control is already set at the factory
and should not require further adjustment. Check
the setting according to the following description
before releasing the cable. Refer to the engine
manual if any adjustment is required.

Choke adjustment

The choke is set at the factory, so no adjustment
is necessary. If adjustment is required, refer to the
engine manual.

Adjusting the carburetor

The carburetor is already set at the factory
and should not require further adjustment.
However, minor adjustments may be necessary to
compensate for differences in fuel, temperature,
altitude or load. Consult the engine manual if the
carburetor really needs any adjustment.
harness
www.trapp.com.br