Adjusting The Backrest - Peg-Perego uno Instrucciones De Uso

fill it without disturbing the baby (fig_b). The basket can also be raised to allow access to the rear footboard
(fig_c).
6 FRONT BAR: insert the front bar (fig_a) and press until the first click. Pull the levers under the front bar towards
you (fig_b) and insert it completely by pushing it forwards (fig_c).
7 The front bar can be lengthened to two positions. To move it to the first position, pull the two levers
underneath towards you (fig_a) and pull it until the first click (fig_b). To move it to the second position, pull
the two levers and the front bar towards you again until the second click (fig_c). It is dangerous to put hot
drinks on the tray.
8 BRAKE: to brake the stroller, push the brake levers on the wheels downwards with your foot, as shown in the
figure. Always set the brake when the stroller is not moving.
9 5-POINT SAFETY HARNESS: to attach the safety harness, insert the two buckles of the waist strap (with
shoulder straps attached) into the leg divider strap until it clicks into place (fig_a). To release it, press both
sides of the buckle and pull the waist strap to the sides at the same time (fig_b).
10 To put on the safety harness, insert the strap adjuster into the slot in the backrest (fig_a) and remove it after
fastening the harness to allow the child to move freely (fig_b). Position the shoulder strap buckle just below
the child's shoulders to ensure the straps remain in place without slipping (fig_c). To tighten the waist strap,
pull in the direction of the arrow on both sides (fig_d). To loosen it, do the opposite. The waist strap can be
tightened as far as the safety lock (fig_e).
11 ADJUSTING THE BACKREST: the stroller backrest can be reclined in three positions. To lower it, raise the handle
(fig_a) and at the same time lock it into the desired position (fig_b); push upwards to raise it.
12 ADJUSTING THE FOOTREST: the footrest has two positions. To lower it, pull the two switches downwards and
lower the footrest at the same time (fig_a). To raise it, pull it up until it clicks (fig_b).
13 SWIVEL WHEELS: the smaller wheels on the stroller swivel. To make them swivel, raise the lever (fig_a). Lower
the level to set them in their fixed position (fig_b).
14 HANDLEBAR: to make the handlebar reversible, pull the clips on it upwards at the same time (fig_a) and move
it to the other side until the final click. IMPORTANT: take care not to hurt the child's hands or arms when doing
this. Adjust the height of the handlebar by pressing on both side buttons at the same time (fig_b).
15 DRINK HOLDER: the drink holder can be attached to both sides of the stroller. Simply click it into place.
16 CARRIAGE AND/OR STROLLER: Uno becomes a carriage when the backrest is in its lowest position, the
footrest is raised, the handlebar is on the opposite side to the backrest and the swivelling wheels are also on
the opposite side to the backrest (fig_a). Uno becomes a stroller when the backrest is raised, the footrest is
lowered, the handlebar is on the same side as the backrest and the swivel wheels are on the opposite side to
the backrest (fig_b).
17 HOOD: turn back the front edge of the hood (fig_a), insert the clips in the slots in the stroller arms (fig_b) and
button them to the rear of the backrest. Button the hood to the insides of the armrests (fig_c) and stretch it,
lowering the joints (fig_d). To transform the hood into a sun canopy, open the zip (fig_e) and unbutton the
rest of the hood.
18 COVER: to transform Uno into a carriage, first lengthen the front bar to the second position and raise the
footrest, slide out the lower part of the cover from under the footrest sack and insert the tabs of the lower
part of the front cover in the slots of the front bar (fig_b). The slots in the front bar will come out when the
front bar is lengthened. If the slots slide back into position, push the two levers under the front bar towards
you. Finally, slip the side eyelets onto the armrests (fig_c). The carriage version without a cover can be seen in
Figure D.
19 Zip the upper part of the cover to the lower part, slip the side eyelets onto the armrests in sequence (fig_a)
and button the cover to the armrests (fig_b). The carriage version with a cover can be seen in Figure C.
20 REMOVING THE WHEELS: to remove the large wheels, press the button (fig_a) and slide the wheel out (fig_b).
To remove the small wheels, press the switch inwards (fig_c) and slide out the wheel at the same time (fig_d).
CLOSING: Before closing the stroller, make sure that the handlebar is positioned on the backrest side and
ensure that all the wheels are in the fixed position. If the hood is on, loosen the joints.
21 To close the stroller, press lever 1 and then lever 2 (fig_a), turn the handlebar forwards and push it
downwards. Complete the procedure by fastening the clips (fig_b). When the UNO stroller is closed, it is
freestanding.
22 TRANSPORT: the stroller has two carrying handles on the sides that allow it to be transported both when
closed and when open (for example, when going down stairs).
23 REMOVABLE LINING: to remove the lining of the stroller, remove the flap on the backrest sack (fig_a). Slide the
sack tabs from the armrests and undo the buttons (fig_b). Unscrew the safety harness on both sides (fig_c)
and pull the sack out. In order to wash the lower part of the cover, release the fasteners from the points on the
footrest frame (fig_d).
THE GANCIOMATIC SYSTEM
The swift, practical Ganciomatic System allows you to attach the Primo Viaggio car seat (sold separately) to