Technical Data; Connecting The Color Monitor - Siemens Nixdorf MCM 1701 Instrucciones De Servicio

Technical data

Dimensions
CRT: 17" (43 cm)
Dot pitch:
Dimensions:
Weight:
Accessories:
Electrical data
Video:
Horizontal Sync.:
Vertikale Sync.:
Power supply:
Power consumption:
Environmental data
Environment class 3K2, DIN IEC 721
Rated range of operation:
relative humidity:
Limit range of operation:
relative humidity:
Condensation must be avoided
A26361-K316-Z1-2-6419
17" color monitor
0,26 mm
(W x H x D): 408 x 415 x 450 mm
22,1 kg
power cable (1,8 m), data cable (1,8 m)
ANALOG, positive, 0,7 V , 75 Ohm SYNC
pp
TTL, Analog 0,3 V ,
pp
(H + V, Sync on green)
30 kHz - 80 kHz (multi-scanning)
TTL, Analog 0,3 V ,
pp
(H + V, Sync on green)
50 kHz - 90 kHz (multi-scanning)
100 V - 127 V, 50 - 60 Hz
200 V - 240 V, 50 - 60Hz
130 watts
15 ˚C .... 32 ˚C
10 % .... 75 %
5 ˚C .... 40 ˚C
5 % .... 85 %
English - 3
17" color monitor

Connecting the color monitor

Please note the information provided in the chapter "Safety" at the
!
beginning of this manual.
Do not cover the ventilation openings of the monitor.
1
1 = BNC/D-SUB Switch
2 = Power connector
The data cable has a 15-point connector for the VGA controller and 5 BNC
connectors for connection to the monitor. The BNC connectors and BNC jacks are
marked with letters or colors.
Ensure that switch BNC/D-SUB (1) points to the left (BNC).
i
Connect the BNC connectors to the relevant jacks on the color monitor.
Plug the data cable at the PC into the VGA controller.
The connection for the monitor interface cable is a 15-pin connector with three
rows.
Then plug the power cable into the rear of the monitor.
Plug the power cable into the rear of the of the PC.
4 - English
4
3
2
3 = D-SUB connector
4 = BNC jacks
A26361-K316-Z1-2-6419