Measuring - HMM Diagnostics ANT+ smartLAB Operación Manual

Beep 3 :
Afterhavingfinishedthesettingupofyourdatathesymbol"0,0"appears
on the display. The smartLAB
the measurement.
Note: Profile and fucntion setup will only be saved on the scale (when
setting manually) when going through the settings until the display shows
„0,0". If not going thourgh the setup until the end, the enterred data
information will not be saved on the scale.
Note: The beep tones are turned off by factory settings. These can either
be turned on manually or automatically by a HMM App or Gateway.

Measuring

After having determined all parameters and user profiles body weight,
adipose and the other values can be determined.
•
Please press „SET" and choose your user profile by using the arrow
keys.DoNOTconfirmbypressing"SET"sinceyouwouldhavetoinsert
andconfirmagainallparameterssuchasgender,bodyweightetc.
• The measurement starts automatically after a few seconds. First of all
your smartLAB
(left display segment). After that the measurement of the other
parameters will start. You will see three circles on the display segments
concerned (please refer to chapter "display & functions" in this user
manual). The scale is detecting the other parameters – content of
water, content of muscles and bone mass (see picture 7).
34
2 long beeps will be heard if the transmission was NOT
successful. Switch through the arrows to ON or OFF and
thenconfirmwith„SET".
®
fit W Body Analyser Scale detects your body weight
®
Pic. 6
fit W Body Analyser Scale is ready to start
kg
Pic. 7