Solution Filter Cleaning; Machine Speed Adjustment - Clarke Vantage 17 Battery Libro De Instrucciones

SOLUTION FILTER CLEANING

1. Empty the solution tank (A, Fig. 28) according to the
procedure shown in the relevant paragraph.
2. Drive the machine on a level ground.
3. Make sure that the switches (B and C, Fig. 28) are in the
"0" position.
4. Remove the transparent cover (D, Fig. 28) and the filter
strainer (E), then clean and reinstall them on the support
(F).
NOTE
Properly install the strainer (E, Fig. 28) in the housing
(G) of the support (F).

MACHINE SPEED ADJUSTMENT

NOTE
The machine speed depends on the type of floor to be
cleaned and on the choice of using brush or pad.
The machine speed can be adjusted according to the
following procedure.
1. Remove the recovery tank as shown in the Use chapter.
2. Adjust the machine speed by means of the screw (A, Fig.
29), according to the following procedure:
• Loosen the screw (B, Fig. 29) on the right side of the
machine, by turning it counter-clockwise.
• Turn the adjusting screw (A, Fig. 29) counter-clockwise
to increase the machine speed.
• Turn the adjusting screw (A, Fig. 29) clockwise to
decrease the machine speed.
• After adjusting, tighten the screw (B, Fig. 29).
3. Install the recovery tank as shown in the Use chapter.
4. With the machine ready to operate, carry out hands-on
tests of the machine speed and, if other adjustments are
necessary, repeat steps 1 to 4.
Operator's Manual - Vantage 17 Battery
ENGLISH
Figure 28
Figure 29
21