Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
6
2
3b

FIRST STEPS

1. Assembling the base
Put the base of the chair on the floor, insert the
pneumatic cylinder, aligning the widest end of the
cylinder with the corresponding groove at the base. Push
the cylinder down to make sure that it fits into place
properly.
2. Assembling the cylinder cover
1 1
Place the cylinder cover over the cylinder and turn it
around twice until it fits.
3a. Assembling the seat
First make sure the locking screw is unscrewed, then
place the seat onto the cylinder facing forward. Once the
seat is fixed to the cylinder, apply strong pressure in a
downwards motion to ensure it is attached well.
3b. Locking the screw
Tighten the locking screw by turning clockwise until it is
securely locked.
3a
4. Removing the high chair seat
Press the button at the bottom front of the
seat to release it.
Lift it up and out, so that just the junior chair seat
remains.
5. Assembling the safety bar
Install the safety bar on the high chair seat. First fix the
screws on the sides and then the screws underneath.
4
5

Publicidad

Tabla de contenido
loading

Tabla de contenido