Electricalshockhazard - Kenmore 116.30412 Manual Del Propietário

LESH
Review this chart to find do-it-yourself solutions for minor performance problems. Any ser-
vice needed, other than those described in this owner's manual, should be performed by
an authorized service representative.
_ _ WARNING ElectricalShockHazard
Disconnect electrical supply before servicing or cleaning the unit.
Failure to do so could result in electrical shock or personal injury.
' I I '
Cleaner won't run.
1. Unplugged at wall outlet.
2. Tripped clrcutt breaker/blown fuse
at household service panel.
3. Onloff switch not turned on.
Poor job of dirt 1. Full or clogged dust bag°
pick-up. 2. Wrong pt_eheight setting.
3. Worn agltatoro
4. Clogged nozzle or bag holder.
5. Clogged hose.
6. Hole in hose_
Cleaner picks up
moveable rugs or
pushes too hard.
Light won't work.
Agitator does not
turn.
PerformanceIndicator,
some models, is red.
Air flow restrlcted
with attachment use.
Sound changes.
Excessive noise as
vacuum is shut off.
Dirt Sensor, some
models, wilt not work.
7_
8.
9.
10,
Broken/mfsplacad belto 7.
Hose not inserted fully. 8,
Motor protection system activated, 9.
Dirtyftlterso 10.
1. Plug in firmly, push on/off switch to
Oll,
2. Reset ctrcutt breaker or replace fuse.
3. Push on!off switch to on.
I. Change bag, (page 14).
2. Adjust setting, (page 7).
3. Replace agitator, (page 21).
4. Check CLOG REMOVAL, (page 19).
5. Check for clogs, (page t9).
6. Replace hose.
Replace/fix belt, (page 16-18).
Insert hose fully, (page 10)_
Check for clogs, (page 19).
Change filters, (page 15).
Wrong pile hetght setting° 1.
1. Burned out light bulbo
1. Broken belt.
2. Bare floor selector In bare
floor setting,
3. Belt Installed incorrectly.
1.
1.
2.
3.
1. Full or clogged dust bag.
2. Dirty filters.
3. Clogged airflow passage.
4o Certatn attachment tools,
1. Attachment use restricts alr flow.
2o New carpet fuzz clogged atr path°
1. Belt rubbtng on carpet/bare floor
selector shaft°
1o [)lrty optic cells.
Adjust setting, (page 7).
Change light bulb, (page 20).
Replace belt, (pages 16_18).
Move selector to the carpet setting,
(page 7).
Check BELT CHANGING AND
AGITATOR CLEANING,
(pages 16-18).
1. Change bag, (page 14).
2. Change filters, (page t5).
3. Clear clog from airflow passage,
(page 19).
4. This is normal° Light should go off
when tool Is removed.
1. CheckA'FTACHMENTS, (page 8)
2. Check CLOG REMOVAL end clean
hose, (page 19),
1. Push selector all the way fon,_ard,
(page 7).
1. Clean optic cells, (page 12).
22