Software Setup; Uninstalling The Eyeseecam Vhit Software - Please Refer To The Eyeseecam; Installation Cd And Instruction; Starting From Otoaccess - Interacoustics EyeSeeCam vHIT Manual De Instrucciones

EyeSeeCam vHIT Instructions for Use - EN
3.6

Software setup

Installation of Otoaccess™ – Please refer to the Otoaccess™ manual and documentation.
Installation of EyeSeeCam vHIT software - Please refer to the EyeSeeCam installation CD and
instruction.
Create ESC as an instrument in Otoaccess™
Figure 3-8 Create EyeSeeCam as an Instrument
To create EyeSeeCam as an Instrument in OtoAccess
instrument and select the instrument you just installed (EyeSeeCam) in the drop down list below
software modules.
Select hardware and set-up type of communication. Please see service manual for the selected
hardware to get information concerning communication. Finally, click on the Create button.
Your OtoAccess™ is now fully programmed for vHIT testing. Remove the EyeSeeCam CDROM from
the drive and store it safely back in the Manual. Once installation has been successful and the
software licenses have been entered, you can start measuring with EyeSeeCam.
3.6.1 Uninstalling the EyeSeeCam vHIT software -

installation CD and instruction.

3.6.2

Starting from OtoAccess™

To start ESC:
1. Double Click the OtoAccess™ icon on the desktop which will open the OtoAccess™
program
2. Select the instrument (in this example, EyeSeeCam) by double-clicking EyeSeeCam in the
Select Instrument box. EyeSeeCam will open in a new window
TM , type in a name (e.g. EyeSeeCam) for the
Please refer to the EyeSeeCam
Page 15