Audio & Video Output Formats; Specifications; Radio Interference; Laser Radiation - Arcam FMJ UDP411 Manual De Instrucciones

START
audio
& video
output
formats
NO
Do you use an AV receiver?
YES
Audio output format
The audio output format available from the digital audio
outputs depends on the soundtrack format being played,
the audio output in use and the Digital Out setting in
NO
Do you connect audio using
the Audio settings menu: see ' A udio' on page E-17.
HDMI?
Use the flowchart on this page to guide you to the
correct setting for your home cinema setup.
YES
Is your receiver HDMI1.3
NO
compatible (Dolby
TrueHD/DTS HD)?
YES
Do you want to play
YES
back Secondary Audio
from Blu-ray Discs?
NO
Use "Bitstream HD"
Use "PCM Stereo"
NO
Do you connect
YES
audio using Optical or Use "Bitstream Re-encode"
Coaxial Digital?
Do you have a 7.1-format
NO NO
Do you have a surround
Use "PCM 5.1" Use "PCM Stereo"
surround sound speaker
sound speaker system?
system?
YES YES
Use "PCM 7.1" Use "PCM 5.1"
E-20
Analogue Audio Output
Digital to Analogue conversion 24-bit 192kHz Delta-Sigma DAC
Signal to noise ratio 110dB CCIR
Harmonic distortion (1kHz) 0.002%

specifications

Frequency response (±0.5dB) 10Hz–20kHz
Output level (0dB) 2.2Vrms
Output impedance 47Ω
Minimum recommended load 5kΩ
Video Outputs
HDMI 19-pin HDMI connector Supported video formats are: 720 x 576p,
720(1440) x 576i, 720 x 480p, 720(1440) x 480i, 1280 x 720p, 1920
x 1080i, 1920 x 1080p, 3840 x 2160p. Audio to 8-channel/96kHz or
2-channel/192kHz (24-bit).
Digital interfaces
USB USB 2.0 High Speed (480 Mbit/s)
Network 10 BASE-T / 100 BASE-TX
Physical
Dimensions W433 x D400 x H100mm
Weight 6.2kg nett/8.5kg packed
Power consumption 20W maximum
Digital output connection 75Ω co-axial optical TOSLINK
Supplied accessories
Mains lead CR301 remote control 2 x AAA batteries
Wi-Fi antenna
E&OE
NOTE: All specification values are typical unless otherwise stated

Radio interference

The UDP411 Blu-ray Disc player is a digital device
which has been designed to very high standards of
electromagnetic compatibility.
All Blu-ray players generate, and can radiate RF
(radio frequency) energy. In some cases this can cause
interference with FM and AM radio reception. If this is
the case, keep the player and its connecting cables as far
from the tuner and its aerials as possible. Connecting
the player and the tuner to different mains sockets can
also help to reduce interference.
EC COUNTRIES – This products have been designed to
comply with EMC Directive 2004/108/EC.
USA – These products comply with FCC Part 15 Class B.

Laser radiation

If the UDP411 Blu-ray Disc
CLASS II
player is operated whilst
LASER PRODUCT
the outer casing is removed,
invisible laser radiation could
cause eye damage.
Continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.
E-21