Fix The Mixer Onto The Cartridge; Transportation And Storage; Decommissioning And Disposal; Troubleshooting - Sulzer Mixpac MK T1 Serie Manual Original

1. Remove nose plug (16) by rotating in counter clockwise.
2. Set the adjustment wheel (4) to dispense the smallest
amount, setting #min.
3. Press the trigger (3) until both components are evenly pres-
sed out of the cartridges.

5.1.5 Fix the mixer onto the cartridge

(Picture on page 9).
1. Remove any foreign matter on the cartridge and the cartridge
guide with a clean cloth.
2. Fix the mixer with the ring to the cartridge outlet.

5.2 Transportation and storage

The dispenser is susceptible to shock, vibration, rain and severe
temperature fluctuations.
Incorrect transport.
Damage to compressed air hose/coupling!
Do not hold the device by the compressed air
■ ■
hose.

5.3 Decommissioning and disposal

The device must not be disposed of with household waste. The
various materials must be disposed of according to the local
regulations, laws and regulations pertaining to the country in
questions.
Observe the disposal instructions of the cartrid-
ge manufacturer.
640078 ver.01
CAUTION

6. Troubleshooting

Troubleshooting pneumatic dispensers
Fault
Dispensing is interrupted.
Applies to
All pneumatic dispensers.
1
Cause
Compressed-air supply has been interrupted.
Remedy
Check the compressed-air line.
Fault
The cartridge cannot be removed from the dispen-
ser.
Applies to
1- and 2-component cartridge dispensers.
2
Cause
The piston(s) are still in position inside the cartridge.
Remedy
Fully retract the pistons (See chapter 3.3).
Fault
Pistons (8) do not advance.
Applies to
1- and 2-component cartridge dispensers.
3
Cause
Cartridge and pistons do not match.
Remedy
Make sure that the cartridge used is suitable for the
dispenser.
Fault
Sausage gets squeezed between cylinder and piston
(8).
Applies to
Sausage dispensers.
4
Cause
Worn piston.
Remedy
Change click-on piston.
Fault
Air noise coming out
Applies to
All pneumatic dispensers.
5
Cause
Faulty compressedair coupling/connection.
Remedy
Check coupling and connections. Inside noise, then
return device for repair.

7. Maintenance and repair

19 EN