Aa Bolt; Bb Washer; Cc Wood Dowel - Twin Star Home 26MM2490 Manual De Instrucciones Adjunto

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Center Left Side Panel (B) and Center
Right Side Panel (C) snug to the Center Front Panel
(O) and Center Shelf (D). Make sure the Wood
Dowels (CC) are seated in the pre-drilled holes.
Then use Bolts (AA) and Washers (BB) through the
pre-drilled holes in the mounting blocks.
Connect the Center Left Side Panel (B), Center
Right Side Panel (C) and Center Front Panel (O)
with Connection Plate, tighten Screws (EE)
through the pre-drilled holes.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC Wood Dowel
EE
Screw
2. Locate Hearth/Base (A) and set out fi nished side up
on the fl oor. Insert one Wood Dowel (CC) into each
of the pre-drilled holes.
Attach the Completed Center Front assembly from
step 1 to the Hearth/Base (A). Make sure that
dowels are seated into the pre-drilled holes in
the Hearth/Base. Using Bolts (AA) and Washers
(BB) attach panels through pre-drilled holes in
the mounting blocks.
HAND TIGHTEN ONLY.
Locate Left Side Panel (E) and Right Side Panel (F),
insert one Wood Dowel (CC) into each of the
pre-drilled holes on the bottom edge of the panels.
Then use Bolts (AA) and Washers (BB) through the
pre-drilled holes in the mounting blocks. Attach the
Side Panels to Hearth / Base (A).
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
Fig. 1
EE
C
x 4
x 4
x 8
x 2
Fig. 2
E
x 8
x 8
x 8
4
B
O
D
BB
AA
F
AA
BB
CC
A