Tabla de contenido
Publicidad
INSTRUCCIONES PARA OPERAR SU VENTILADOR DE TECHO
2
HOW TO OPERATE YOUR CEILING FAN
Restore electrical power to the outlet box by turning on the electricity at the main fuse box.
To make the fan operational, open battery door by pressing and sliding down the battery door.
Install two AAA 1.5V batteries (included) into the hand-held remote transmitter(if not used for long
periods of time, remove the batteries to prevent damage to the transmitter).
1. The remote control adopts RF wireless digit emission technique, biunique controlled.
2. The transmitter and receiver are matched at the factory. Please follow step#4 to repair when the
pairing is failed.
3. Turn off the fan power and then restore it, press and hold the "fan stop" button for 5 seconds,
within 60 seconds after you restore the power, the fan will automatic turn on at low speed and then
turn off, with the light flashing 3 times.
(NOTE: The pairing process is not accepted after 60 seconds when you restore supply power)
4. Please note that the transmitter can pair with multiple receivers. When the transmitter does not
control the receiver, please check if any similar remote controls are working nearby, disconnect them
and then proceed with pairing process again.
5. Store the remote transmitter away from excessive heat or humidity.
6. Low power of battery or not-used for long time should be replaced.
22
ETL-ES-Harrison-WH20
Publicidad
Tabla de contenido
