Duty Cycle - Klein Tools CL800E Manual De Instrucciones

ENGLISH
FREQUENCY (AUTO-RANGING)
9.999 Hz
99.99 Hz
999.9 Hz
9.999 kHz
99.99 kHz
500.00 kHz
Sensitivity: > 8 V RMS
Maximum input: 600 V DC or 600 V AC RMS

DUTY CYCLE

1% to 99.9%
Pulse width: 0.1 ms - 100 ms
Frequency width: 5 Hz to 10 kHz
Sensitivity: >8 V RMS
Maximum input: 600 V DC or 600 V AC RMS
OTHER MEASUREMENT APPLICATIONS
Maximum input: 600 V AC RMS or 600 V DC
• Diode test: Max. 1.5 mA, open circuit voltage ~3.0 V DC
• Continuity check: Audible signal <50 Ω, test current <0.35 mA
• Sampling frequency: 3 samples per second
• Low impedance (Low Z): Input impedence >3 kΩ
• Auto power off: After ~30 minutes of inactivity
• Overload: 'OL' indicated on display, overload protection
1,000 V in Voltage setting, 600 V RMS in all other settings
• Polarity: '-' on the display indicates negative polarity
• Display: 3-5/6 digit, 6,000 count LCD
To ensure safe operation and service of the meter, please follow
these instructions. Failure to observe these warnings can result
in severe injury or death.
• Before every use, verify meter operation by measuring a known
voltage or current.
• Never use the meter on a circuit with voltages that exceed the
category-based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Only use with CAT IV-rated test leads.
4
ELECTRICAL SPECIFICATIONS
0.001 Hz
0.01 Hz
0.1 Hz
1 Hz
10 Hz
100 Hz
0.1%
Max input 600 V RMS
WARNINGS
±(1.0% + 5 digits)
±(1.2% + 2 digits)