Technical Data - HSM Classic 412.2 Instrucciones De Servicio

9 Disposal / Recycling
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.

10 Technical data

Cutting type
Shred size (mm)
Sa fe ty ra ting DIN 66399
Cutting ca pa ci ty* (sheets), DIN A4 70 g/m
Cutting speed
Weight
Noise level (Idle running/ load)
Lo ading width
Voltage
Power for the maximum number of sheets
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL)
Dimensions W x D x H (mm)
Volume of shredded material bag
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one specifi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
06/2014
2
80 g/m
2
Classic 412.2
english english
Cross cut
3.9 x 50
P-3 / O-2 / T-3 / E-2
38 - 40
33 - 35
110 mm/s
85 kg
60 dB(A) / 75 dB(A)
400 mm
230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
2100 W
-10 °C to +25 °C
max. 90 %, without condensation
max. 2,000 m
595 x 470 x 1245
146 l
17