Oehlbach Tracking Force Manual Del Usuario página 4

Thank you for choosing an Oehlbach ® quality product. Please read these operating instructions in detail to ensure unre-
stricted and faultless functioning of the device.
Important safety instructions:
To avoid the risk of fire, electrical short circuit or damage to the product, please follow these instructions:
1.
Do not expose the product to rain / moisture. Do not place containers filled with water on the product.
2.
Do not install the product in a bookshelf, built-in closet or similar confined space. Make sure that the unit is well
ventilated.
3.
To prevent electrical short circuit or fire due to overheating, do not cover the unit.
4.
Do not position the unit near heat sources such as radiators, stoves, etc.
5.
Do not use near open fire or candles.
6.
Clean the device only with a dry cloth.
7.
Use only the supplied accessories.
8.
In case of service, please contact qualified service personnel only.
Compliance with EU directives
This product may carry the CE mark. It complies with the EU Low Voltage Directive 2014/35/EU; EU Electromagnetic
Compatibility Directive 2014/30/EU; EU RoHS Directive 2011/65/EU; EU Waste Electrical and Electronic Equipment (WEEE)
Directive 2012/19/EC.
Disposal instructions
According to the European Directive 2012/19/EC, all electrical and electronic equipment must be disposed of
separately via local collection points. Please observe local regulations and do not dispose of your old devices with
normal household waste.
The Tracking Force Box contains the following parts:
Tonearm Scale Tracking Force, Operating Instructions
Specification
Temperature range:
Permissible relative
Power supply:
Dimensions:
Measuring range:
Measurement modes:
Controls:
Finish:
Material:
Operation
Preparation
Before you use the Tonearm Scale Tracking Force, please ensure that mobile phones are at least 50 cm away from the
product, as this can have a negative effect on the measuring characteristics of the device. Place the tonearm scale on a stable
and vibration-free surface.
Operating modes
1.
Place the Tonearm Scale Tracking Force on the record player.
2.
Turn on the unit using the on/off button.
3.
Place the tonearm on the round silver measuring surface of the scale to measure its support weight.
4.
To reset the tonearm balance to zero, press the tare switch.
Notes
∙
If the weight exceeds the maximum of 200 g, an ERR symbol is displayed on the screen.
∙
By pressing the Unit button, the measuring unit can be switched.
4
10 to +30°C
humidity: 5 to 90%.
2 x batteries type micro/AAA
65 x 115 x 16 (W x H x D in mm)
0.01g - 200g
g, oz, tl, ct, gn
On/Off switch, Unit selection, Pcs selection, Tare switch
Silver coloured
ABS plastic, stainless steel plate