Legal Information; Contact Details; About This Guide; Safety Instructions - Enduro Magicard Manual Del Usuario

Tabla de contenido

Publicidad

Legal Information

ABOUT THIS GUIDE:

This guide is to assist you with the set-up and use of your Enduro ID card printer.
The information contained in this guide is subject to change without notice. Ultra Electronics Limited shall not be liable for errors contained herein or for
incidental or consequential damages in connection with the furnishing, performance or use of this material.
This document contains proprietary information belonging to Ultra Electronics Limited and may not wholly or partially be copied, stored in a data retrieval
system, disclosed to third parties or used for any purpose other than that for which is was supplied, without the express written authority of Ultra Electronics
Limited. All rights are reserved.
Magicard
®
is registered as a trademark with the United States Patent and Trademark Office, Reg. No. 2,197,276.
The HoloKote
®
feature of Magicard
®
printers is protected by US PATENT No: 5,990,918 and by European PATENT SPECIFICATION EP 0 817 726 B1.
Microsoft and Windows are trademarks of Microsoft Corporation.
© 2008 Ultra Electronics Limited.

SAFETY INSTRUCTIONS:

To prevent electric shock, do not remove covers.
Do not attempt to service the printer yourself.
There are no user serviceable parts inside.
Use only a power source within the limits marked on the printer.
Avoid touching the thermal printing edge of the thermal print head as grease and contamination will shorten its life.
Ensure that the power supply cord is not longer than 6 feet (2 metres) and used with a properly grounded connection.
Before transporting the printer, remove the dye film and card hoppers, and pack the printer in its original packaging.
If using this printer in Germany:
To provide adequate short-circuit protection and over-current protection for this printer, the building installation must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem 16-AÜberstromschalter abgesichert ist.
LIMITED WARRANTY:
1) Coverage: Ultra Electronics Ltd Warrants that the MAGICARD printer shipped with this Warranty statement will conform to the manufacturers specifications
and be free from defects in materials or workmanship for a period of 1 year from the date of purchase by the user (2 years in EU, North America and selected
other countries), but there are additional conditions on the Print head Warranty (see paragraph 2).
2) Limited Print head Warranty: Ultra warrants that, under normal use and service, thermal print heads will be free from defects in material and workmanship for
a period of one year (2 years in EU and North America) from the date of purchase or for a quantity of 10,000 printed cards, whichever comes first, provided
that Ultra-approved card media is utilised. If a Warranty claim is submitted for a defective print head, Ultra will have the right to inspect the print head and
samples of the printed and blank ID cards used with it for the purpose of verifying that the claimed defect has not been caused by non-Ultra approved
media, or by foreign particles or substances which have caused chemical or physical damage. Ultra's decision in any such claims shall be final.
3) Warranty Claims: If the MAGICARD printer proves defective during this period, please contact the Ultra Service Center. The Ultra Service Center personnel
may first ask you to carry out certain simple checks to confirm the nature of the problem, and if a return is appropriate they will give you a Magicard Return
Authorisation Number (MRAN) and consignment instructions to the appropriate repair center. Ultra will, repair or replace the defective parts at no charge to
the customer.
4) Warranty Limitations: The Warranty does not apply to MAGICARD printers that have been:
• Damaged through physical or electrical mishandling.
• Damaged through operation in environments which are outside normal office conditions in terms of corrosive atmosphere,
temperature, humidity, shock or vibration.
EMC:
EMC:
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications. Le présent
appareil numérique n'émet pas de bruits radioélectriques dépassant les
limites applicable aux appareils numériques de la class A prescrites dans
le Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
EU Declaration of Conformity
The EU Directives covered by this Declaration
89/336/EEC Electromagnetic Compatibility Directive, amended by
92/31/EEC & 93/68/EEC
72/23/EEC Low Voltage Equipment Directive, amended by 93/68/EEC
The Product Covered by this Declaration
Magicard Enduro Card Printer
The Basis on which Conformity is being Declared
The product identified above complies with the requirements of the above
EU Directives by meeting the following standards
BS EN 50 081-1
EMC Generic Emission Standard Part 1
BS EN 50 082-1
EMC Generic Emission Standard Part 1
BS EN 60 950 : 1992 Safety of Information Technology Equipment
including Electrical Business Equipment.

Contact details

For more information about your Enduro or for
technical support contact your local Magicard
authorised dealer or visit
Register your printer online at www.magicard.com
Magicard Headquarters
Ultra Electronics Limited, MAGICARD Service Centre, Waverley House, Hampshire Road, Granby Estate, Weymouth, Dorset, DT4 9XD, UK
19
English
www.magicard.com

Publicidad

Tabla de contenido
loading

Tabla de contenido