Assembly - Chef's Grill RT2417S-1 Manual De Instrucciones

UNPACKING
After removing all parts and hardware pack from the top of the shipping box, and when the only part showing is
the grill head, use a ox cutting knife to slice down the sides of the box. Be careful of staples along shipping box
b
edges.
Remove the steel and cardboard corner supports from the box and the styrofoam side pieces from the grill head.
Open grill lid and remove all packaged parts and packing material. Allow grill head to rest on cardboard until
placing grill head on cart in Step 9.
WARNING: Assemble the grill on a flat level surface. Compare the parts and hardware with the list and
diagrams. Do not attempt assembly if any part is missing or damaged.
1. Attach the locking casters (Q) and the
casters (R) to the bottom panel (P) using
12 screws (AA). When this process is
completed, turn the bottom panel over.
The two locking casters (Q) should be at
the back of the grill.
Hardware Used
3/16-24 x 1/2 in.
AA
Screw
2. Align the holes in the rear panel (L) with the
holes in the bottom panel (P) and insert
screws (AA) into the aligned holes.
Hardware Used
3/16-24 x 1/2 in.
AA
Screw
Note: Do not tighten the screws completely. Leave
at least one full turn on each. After all the screws
have been installed, go back and tighten them
fully.
1
X 12
R
2
AA
X 3
17
AA
P
Q
P
L