Status Signals; Directives And Manufacturer's Declaration; Electromagnetic Environment - Ottobock 1B1-2 Meridium Instrucciones De Uso

Error message

14.2.4 Status signals

Battery charger is connected
LED on LED on bat­
power tery charger
supply
Battery charger disconnected
Beep Vibration
signal signal
1x short 1x short
Battery charge level
Battery char­
ger
Battery is being charged, battery charge level is less than 50%
Battery is being charged, battery charge level is over 50%
Battery is fully charged (or connection with product is interrupted).
Take note of the confirmation signal for differentiation.
When the battery charger is connected or disconnected, a self-test is conduc­
ted and confirmed by a beep and vibration signal.
The battery is fully charged if this signal is heard.
If no signal is emitted, the connection to the product is interrupted.

14.3 Directives and manufacturer's declaration

14.3.1 Electromagnetic environment

This product is designed for operation in the following electromagnetic environments:
• Operation in a professional healthcare facility (e.g. hospital, etc.)
• Operation in areas of home healthcare (e.g. use at home, use outdoors)
The customer or user of the product must ensure that it is operated in such an environment.
Observe the safety notices in the section "Information on proximity to certain areas" (see
Page 54).
82
Cause
A current connection to
the prosthesis was inter­
rupted
Event
Power supply and battery charger operational
Event
Self-test completed successfully. Product is operational.
Correction
Check the following points:
• Distance from the prosthesis to the
device
• Charge level of the prosthesis
• Bluetooth on the prosthesis switched
on? (see Page 72)
• Hold the component with the sole of the
foot facing up to make the component
"visible" for 2 minutes.
• Prosthesis switched on? (Switching off
the product)
• If multiple prostheses were stored, was
the correct prosthesis selected?