Checking Chain Tension - Stihl MS 461 R Manual De Instrucciones

Ocultar thumbs Ver también para MS 461 R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Use the screwdriver to turn the
N
screw (1) to the right until the saw
chain rests against the underside of
the guide bar
Raise the guide bar further and
N
tighten the nuts securely
Continue with "Checking the chain
N
tension"
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period!
Check chain tension frequently –
N
see "Operating Instructions"
30

Checking Chain Tension

Switch off the engine
N
Put on protective gloves
N
Versions with depth limiter (special
accessory)
1
2
Loosen adjusting screw (1)
N
Push the slide (2) toward the engine
N
as far as it will go
continue with "For all versions"
N
For all versions
The saw chain must lie against the
N
bottom of the bar – and it must be
possible to pull it across the guide
bar by hand when the chain brake is
released
If necessary, retension saw chain
N
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period.
Check chain tension frequently –
N
see "Operating Instructions"
Versions with depth limiter
Push the slide toward the tip of the
N
bar as far as it will go or set the
desired cutting depth
Tighten the adjusting screw
N
MS 461 R

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ms 461

Tabla de contenido