Instructions Before Installation; Installing Mini Heki 40 X 40 - Dometic Mini Heki Instrucciones De Montaje Y De Uso

Instructions before installation

6 Instructions before installation
➤ Before installation, check the roof thickness of your vehicle. Consult the vehicle
manufacturer if you have any questions.
➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts), cables
and cabinets in the vehicle interior must not be damaged when sawing the
hole.
– Sufficient space needs to be available for installing the inner and outer frames.
– Only fit the roof light on flat and parallel interior and exterior roof areas with a
maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
6.1 Pressing out the hole
See fig. 2
6.2 Using the reinforcing rails
Supplementary to fig. 3
➤ Before installation, check whether the roof hole needs reinforcing.
➤ Remove the foam according to the width of your reinforcing rail (not in scope of
delivery) (A).
➤ Fit the reinforcing rails (B).
7

Installing Mini Heki 40 x 40

Supplementary to fig. 4
The scope of delivery contains a mounting frame, which is suitable for roof
thicknesses of 25 – 42 mm or 43 – 60 mm.
➤ Measure your roof thickness W.
➤ Shorten the sleeves to size H (see table).
➤ Use the screws with appropriate lengths (see table).
Siehe fig. 5
➤ Check that the roof light has sufficient space around (approx. 1 to 2 mm) it in the
roof opening.
6
Mini Heki 40 x 40
EN