Disassembly Of Crankcase, Cranckshaft And Lay Shaft - Husqvarna SM 610 2007 Manual De Oficina

SMONTAGGIO MOTORE
ENGINE DISASSEMBLY
DÉCOMPOSITION MOTEUR
MOTORAUSBAU
DESMONTAJE MOTOR

Disassembly of crankcase, cranckshaft and lay shaft

Perform the following on the R.H. crankcase, proceed as follows.
Straighten the safety washers; remove the nuts (1, 2) securing the crankshaft
and lay shaft (remove the layshaft fastening nut on L.H. side too).
Remove the lay shaft counterweight (3) and the key.
Remove the two gears (A) on the crankshaft and the key.
Remove the two screws locking the blade valve (4) and remove it.
Using a 8 mm wrench, unlock the 2 screws then remove the neutral sensor
(5) with seal ring, pin and spring.
Withdraw the timing chain (6).
Part. N. 8000 A8466 (12-2006)
F.25