Laerdal AED Trainer 2 Instrucciones De Utilizacion página 3

Copy Approved – Check Revision Before Use
O O V V E E R R V V I I E E W W
A O O n n / / O O f f f f b b u u t t t t o o n n . . Turns unit on and initiates voice prompts.
Press once to turn unit on. Press again to turn off.
B P P a a d d s s C C o o n n n n e e c c t t o o r r S S o o c c k k e e t t . . Insert the training pads
connector into the pads connector socket. The LED
flashes to indicate the socket location. The LED is covered
when the defibrillation pad connector is properly inserted
in the socket.
C S S p p e e a a k k e e r r . Provides audible instructions and information
about the unit and the patient's status. The speaker
volume can be controlled by the two blue Up / Down
buttons or the remote control. The last setting will be
stored and maintained even if the unit has been
turned off.
D S S h h o o c c k k B B u u t t t t o o n n . . Controls simulated shock delivery. The button flashes when the unit is ready to deliver a
simulated shock.
U U p p / / D D o o w w n n B B u u t t t t o o n n s s . Control the voice prompt volume during use. Important: These "option" buttons
E
have different functions on the real automatic external defibrillators. Please refer to the FR2 AED User's Guide.
F O O p p e e r r a a t t o o r r D D i i s s p p l l a a y y a a n n d d R R e e m m o o t t e e C C o o n n t t r r o o l l R R e e c c e e i i v v e e r r . . Indicates voice prompt volume, training scenario
selection, and responses to remote control inputs. (See the diagram and button description of the remote
control for examples of these indicators).
S S t t a a t t u u s s W W i i n n d d o o w w . This window simulates the FR2 status display. By pulling on the tab you can switch
G
between the hour glass symbol and the X. For details of these symbols refer to your FR2 User's Guide.
H B B a a t t t t e e r r y y . The Laerdal AED Trainer 2 battery resembles that of the FR2 AED. Insertion and removal mechanisms
are similar. However, the Laerdal AED Trainer 2 battery case holds six (6) replaceable C-cell alkaline batteries.
I T T r r a a i i n n i i n n g g P P a a d d s s . . Training pads resemble those used with the FR2, however
they do not deliver a shock. Training pads with a yellow connector are for
use with any manikin; those with a white connector and "Laerdal Link
Technology" logo are for use with AED Little Anne and AED Resusci Anne
manikins with Laerdal Link Technology. NOTE: The Laerdal AED Trainer 2
comes with one set of training pads with a yellow connector. When the
yellow connector is inserted into the trainer's connector socket, the trainer
responds as if the pads are attached to a patient and proceeds through the
treatment protocol. The training pads are for training use only and will not
function with an actual FR2 AED.
J R R e e m m o o t t e e C C o o n n t t r r o o l l ( ( o o p p t t i i o o n n a a l l ) ) The optional remote control can be used to control the different features of
the Laerdal AED Trainer 2 during training sessions (see accessories on page 5). Refer to the diagram below
with individual button functions described. Most remote control actions generate a red digital character
response in the operator display window on the Laerdal AED Trainer 2 device as shown in the table below.
Att 1 to PRO-M07-0071.pdf 3
B
C
3
A H
G
E
F
D
1/14/2014 11:33:25 AM