Disassembly Of The Pump; Cleaning; Pump Assembly - NUK Expressive Instrucciones De Operación

CAUTION: Always hold the container (5) upright when it
contains milk or the milk may spill out.
For the following please refer to "Overview of Parts".
1. Unplug the voltage adapter (7) from the pump motor
unit (8).
2. Unscrew the milk storage container (5) from the
connection ring (3).
3. Remove the lip valve (4) from the breast shield (2).
Hygiene is of priority when handling breast milk and all
parts that come into contact with it. The pump should
therefore only be used in a clean and sanitized condition.
All accessories and parts, apart from the pump motor unit
(8), battery compartment lid (10), and voltage adaptor (7)
must be thoroughly cleaned.
NOTE: Prior to first use, clean the NUK
Container (5) and Nipple (13) by boiling in water for
5 minutes.
CAUTION: Unplug the voltage adapter (7) from the power
outlet before cleaning.
1. Disassemble the pump according to Section 5.
2. After each use, wash all parts except for the pump
motor unit (8), battery compartment lid (10) and voltage
adapter (7) either by hand or using a dishwasher.
Before using the pump, disassemble and clean according to the instructions in sections 5 and 6.
1. Insert the overflow
protection valve (1)
into the breast
shield (2) with
the knob pointing
upwards.
03_62766_5369_A_SEBP_IB_New Pump_REL_8-29-13.indd 7

5. Disassembly of the Pump

6. Cleaning

Breast Milk
®

7. Pump Assembly

1
4. Unscrew the connection ring (3) from the breast shield
(2) and pump motor unit (8).
5. Separate the breast shield (2) from the pump motor
unit (8).
6. Take the overflow protection valve (1) out of the breast
shield (2) by turning it upside down.
NOTE: Remove batteries if product is to be left unused for
an extended period of time.
2a. To wash by hand, wash parts using plenty of hot
water and liquid dishwashing soap, then rinse with
hot water for 10 to 15 seconds. Clean the lip valve
carefully to avoid damaging the material. Gently
squeeze the valve to open it slightly during cleaning.
Rinse thoroughly.
2b. To wash in a dishwasher, place the parts in the top
rack of the dishwasher and start the cleaning cycle.
Note that slight discoloration of the material may
occur in rare cases.
3. Wipe the pump motor unit (8) and battery
compartment lid (10) with a damp cloth. This cleaning
is sufficient because the pump motor unit (8) and
battery compartment lid (10) do not come into
immediate contact with the milk.
CAUTION: Never immerse the pump motor unit (8) or
voltage adapter (7) in water as this could damage the
electric systems.
2. Place the pump
motor unit (8)
on the breast
shield (2).
7
NUK Graphics SKU
07_NCI
Engineering Graphic Design
728 Booster Blvd
UPC Code Die
Reedsburg, WI 53959
608-524-9312
N/A N/A
2
8/29/2013 12:06:14 PM
®
®
SAP Packaging Number Flat S
N/A
Date
Product Description
Created
NUK Logo - Process Black 1-29-10-pab x