Tommee Tippee 1092 Instrucciones página 11

STERILIZING
Before first use place in boiling water for 5 minutes. This is to ensure hygiene. Suitable for steam sterilization.
• After each use disassemble all parts of the bottle.
• Wash thoroughly with hot soapy water.
• Rinse all components using fresh water.
• After rinsing, re-assemble the nipple and screw ring.
• Place all components including the nipple and screw ring assembly in the sterilizer. The closer to nature microwave or electric sterilizer
are suitable. After sterilization the nipple can then be picked up using the screw ring as normal.
ASSEMBLY OF YOUR NIPPLE AND SCREW RING
• Due to the larger size of Tommee Tippee's nipple and screw ring, care needs to be taken during assembly to ensure that the nipple is in
the correct position (shown below).
• The best method of assembly of the nipple and screw ring is to carefully pull the nipple through the ring in different directions to
ensure the silicone lip fully clips' over the edge of the screw ring. The area where the nipple and screw ring meet should be flush.
STORAGE AND USE
Inspect before each use and pull the feeding nipple in all directions. Throw away at the first signs of damage or weakness. Do not leave a
feeding nipple in direct sunlight or heat, or leave in disinfectant ("sterilizing solution") for longer than recommended, as this may weaken
the nipple. Do not store with or allow to come into contact with solvents or harsh chemicals. Not suitable for use in a grill or a microwave
oven with the grill feature switched on. Keep all components not in use out of reach of children. For safety and hygiene reasons it is
recommended the feeding nipple is replaced at least every 2 months. Do not heat in a microwave. This product is for home use, and is not
suitable for use in the presence of a FLAMMABLE ANAESTHETIC MIXTURE WITH AIR or WITH OXYGEN OR NITROUS OXIDE.