Guidance And Manufacturer's Declaration - Electromagnetic Emissions; Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Tommee Tippee 1092 Instrucciones

Guidance and manufacturer's declaration – electromagnetic emissions
The MODEL 1092 is intended for use in the electromagnetic environment speci ed below.
The customer or the user of the MODEL 1063 should assure that it is used in such an environment.
Emissions
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage uctuations/
icker emissions IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity
The MODEL 1092 is intended for use in the electromagnetic environment speci ed below.
The customer or the user of the MODEL 1092 should assure that it is used in such an environment.
Immunity test IEC 60601 test level
Electrostatic ±6 kV contact
discharge (ESD) ±8 kV air
IEC 61000-4-2
Electrical fast ±2 kV for power
transient/burst supply lines
IEC 61000-4-4
Surge ±1 kV line(s)
IEC 61000-4-5 and neutral
Voltage dips, <5 % UT
short interruptions (>95 % dip in UT)
and voltage for 0,5 cycle
variations on 40 % UT
power supply (60 % dip in UT)
input lines for 5 cycles
IEC 61000-4-11 70 % UT
(30 % dip in UT)
for 25 cycles
<5 % UT
(>95 % dip in UT)
for 5s
Power frequency 3 A/m
(50/60 Hz)
magnetic eld
IEC 61000-4-8
Compliance Electromagnetic environment-guidance
Group 1 The MODEL 1092 uses RF energy only for its internal function. Therefore, its RF emissions
are very low and are not likely to cause any interference in nearby electronic equipment.
Class B The MODEL 1092 is suitable for use in all establishments, including domestic
establishments and those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic purposes.
Class A
Complies
Compliance level
±6 kV contact
±8 kV air
±2 kV for power
supply lines
±1 kV line(s)
and neutral
<5 % UT
(>95 % dip in UT)
for 0,5 cycle
40 % UT
(60 % dip in UT)
for 5 cycles
70 % UT
(30 % dip in UT)
for 25 cycles)
<5 % UT
(>95 % dip in UT)
for 5s
3 A/m
NOTE UT is the a.c. mains voltage prior to application of the test level
Electromagnetic environment-guidance
Floors should be wood, concrete or ceramic tile. If oors are covered with
synthetic material, the relative humidity should be at least 30 %.
Mains power quality should be that of a
typical commercial or hospital environment.
Mains power quality should be that of a
typical commercial or hospital environment.
Mains power quality should be that of a typical commercial or hospital
environment. If a dips or an interruption of mains power occurs,
the current of the MODEL 1063 may be dropped o from normal level,
it may be necessary to use uninterruptible power supply or a battery.
Power frequency magnetic elds should be at levels characteristic
of a typical location in a typical commercial or hospital environment.