Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING THE DOUBLE ELECTRIC BREAST PUMP
Wash your hands thoroughly before handling the pump.
Wash and sterilize your breast pump before using. Follow instructions in section for CLEANING, STERILIZING AND MAINTENANCE.
1
1.
Make sure the silicone inserts are securely attached to both horns. Clip lip over end of cup first, then push tube through funnel, ensuring lip
is fully clipped over the other side also.
2.
Push both horns onto the lower pump body as far as they will go.
3.
Push diaphragm down into lower pump body as far as it will go and push diaphragm cap over the top as far as it will go until it is sealed.
4.
Push upper pump body and lower pump body together. They will click into place.
5.
Push valve onto lower pump body.
6
7
6.
Screw bottle onto lower pump body.
7.
Connect air tube onto upper pump body and the air tube socket of the motor unit. This is on the LEFT of the two sockets on the motor unit.
8.
Plug the electric adapter into the electric adapter socket of the motor unit. This is on the RIGHT.
9.
Plug the electric adapter into the mains power supply.
INSTALLING THE BATTERY FOR THE FIRST TIME
1.
Before first use, the battery must be charged for at least 3 hours.
2.
To install, remove screw, slide open the battery cover to remove.
3.
Insert the battery as indicated inside the battery compartment and push the cover back into place until it clicks shut.
4.
Secure with screw.
5.
Battery will recharge when plugged in at the mains and the digital display panel is closed.
2
3
1
2
Help the environment by disposing of your product responsibly. The product and batteries must not be disposed of in the domestic waste as
they contain substances which can be damaging to the environment and health. Please use designated collection points or recycling facilities
when disposing of the item or batteries.
CAUTION :
Don't immerse in water.
Don't discard or leave the battery near heat source. May explode if disposed into fire.
Don't connect the positive and negative terminal directly.
Don't strike, throw or trample the battery.
Never disassemble the cell.
Battery pack Model: 455068P (2S1P) can only use on the double Breast Pump
For replacement Lithium Ion Polymer batteries 455068P (2SIP), contact www.tommeetippee.com, or use the recommended Mains Adapter
(PSU) S01563C DEBP (522663) conforms to the requirements of IEC 60601-1-2 (EMC). Adapter (501513A) conforms to the requirement of
UL 60601-1
2
3
8
4
4
5
9
Publicidad
Tabla de contenido
