Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE DOUBLE ELECTRIC BREAST PUMP
2
1
1.
Ensure that the breast pump parts that come into contact with the breast or milk have been cleaned and sterilized. Wash your hands
before touching the breast pump or your breasts and avoid touching inside the breast pump or the milk protection pod. Find a
comfortable chair where you can relax.
2.
Ensure the connector switch is in the central position for double expressing.
3.
BEFORE placing the breast pump on the breast, switch on to level 1 by sliding the digital display panel up on the motor. The time will
commence on the digital display panel.
4.
Place both horns over the breast.
5.
Ensure the horn has a good seal to the breast. IF AIR CAN GET IN THERE WILL BE LOW OR NO SUCTION.
6.
Once your milk starts to flow freely after approximately one minute, we recommend you press the level 2 touch pad. The pad LED will light
up green to show you are on level 2.
7
3
3
7.
To increase the expression level, press level 3 touch pad. If expressing is uncomfortable at this level, switch back to the lower level by
touching the level 2 touch pad.
8.
If you would like to express faster than level 3, press level 4 or 5 touch pad until you find the expression level that suits you to achieve
maximum comfort.
9.
Do not fill higher than the maximum level indicated on the bottle.
10. To switch off slide the digital display panel down.
11.
Once you have completely finished pumping, unplug the breast pump.
12. You do not need to sterilize your pump parts until you are ready to use it again, but it is recommended to clean immediately after use to
remove milk residue.
13. Cover and store the expressed milk for later use.
USING THE DOUBLE ELECTRIC BREAST PUMP AS A SINGLE ELECTRIC BREAST PUMP
•
To use the breast pump for single pumping, slide the connector switch to the left for expressing from the left breast, or to the right for
expressing from the right breast.
•
The second horn does not need to be connected for single pumping.
WARNING!
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.
• The battery is to be disposed of safely.
• If the supply cord is damaged, it must be replaced by the manufacturer, in order to avoid a hazard.
• Do not immerse motor unit, single to double connector and air tube in water or clean with wet sponge or cloth.
• Keep all components out of reach of children.
• Children should be supervised to ensure that they do not play with the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• The use of accessories, transducers and cables other than those specified with the exception of transducers and cables sold by
the manufacturer of the MODEL 1092 as replacement parts for internal components may result in increased EMISSIONS or
decreased IMMUNITY of the MODEL 1092.
• MODEL 1092 should not be used adjacent to or stacked with other equipment.
3
4
8
02:00
4
5
6
9
10
ml
fl oz
2
Publicidad
Tabla de contenido
