Preparations At The Workplace; Inserting The Battery - Hilti RT 6-A22 Manual De Instrucciones

Noise information
Sound power level LWA
Uncertainty for the sound power level KWA
Emission sound pressure level LpA
Uncertainty for the sound pressure level KpA
Vibration information
Vibration value ah,D
Uncertainty for the given vibration value K
4.3 Table correlating nosepieces and blind rivets to be used
Nosepiece designation
RTN 2.4
RTN 3.2
RTN 4.0
RTN 4.8
5

Preparations at the workplace

5.1 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.1.2

Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
18 English
Printed: 30.07.2019 | Doc-Nr: PUB / 5466619 / 000 / 02
Blind rivet diameter, all commercially available
materials
2.4 mm
3.2 mm
4.0 mm
4.8 mm
5.0 mm (aluminum blind rivets only)
2225140
*2225140*
RT 6-A22
98.9 dB(A)
3 dB(A)
85.9 dB(A)
3 dB(A)
RT 6-A22
0.94 m/s²
0.033 m/s²