Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4 Setup
4.1 Items supplied with the radio
Before using the transceiver, always make sure that the semi-rigid
EVA box contains the following items:
• The transceiver with the rubber (fixed) aerial and the rechargeable
battery pack
• The holster in rigid polycarbonate with rotating clip to fix the radio
to the belt. To properly fix the radio into the holster, push the
holster.
• The desktop battery-charger (that includes the charging seat, the
AC adapter and AC cable)
• Belt clip
• Rubber cap for the Mike/SPK jacks
• The operating manual (this manual)
If any of the above-described parts are missing or damaged,
immediately contact the retailer.
2 To operate the radio, use the Ni-MH or Li-Ion battery pack.
4.2 Fixing/removing
the optional belt clip
To remove the clip from the battery pack,
unhook the battery pack from the radio,
then pull the release lever, situated on
the upper part of the clip, outwards, then
remove it pulling it upwards.
To reinsert the clip, insert the guides into
the grooves on the rear of the battery
pack, then slide the clip downwards until it snaps in place.
4.3 Removing/installing the battery pack
Depending on the model, the transceiver can be fitted with the
following battery packs:
• BP4511 - NiMH battery pack, 1,100 mAh
• BP4522 - Li-Ion battery pack, 2,200 mAh
I If you are planning not to use the transceiver for a long period
of time, remove the battery pack.
I Be careful not to soil/damage the contacts of the battery
compartment of the radio and battery pack.
4.3.a Removing/installing battery pack
To insert the battery pack:
1) Insert the battery pack as shown in the figure.
2) Push the battery pack down towards the transceiver until it clicks
in place.
Lever
Guide
Groove
To remove the battery pack:
1) Press and hold down the battery release button.
2) Remove the battery pack from the upper side of the transceiver.
1
2
7
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
