Environmental Protection; Technical Specifications - Metabo WEF 9-125 Quick Manual Original

13. Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2012/
19/EU on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
returned for environmentally compatible recycling.
Special instructions for cordless machines:
Battery packs must not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-
circuiting (e. g. by protecting them with adhesive
tape).

14. Technical specifications

Explanation of details on page 3. Subject to
changes serving technical progress.
U = Voltage of battery pack
D = max. diameter of accessory
max
t = Max. permitted thickness of clamping
max,1
shank on accessory when using
clamping nut (18)
t = max. permitted thickness of clamping
max,2
shank on accessory when using
"Quick"clamping nut (2)
t = Roughing wheel/cut-off wheel:
max,3
max. permissible thickness of the
accessory tool
M = Spindle thread
l = Length of the grinding spindle
n* = No-load speed (maximum speed)
P = Nominal power input
1
P = Power output
2
m = Weight with smallest battery pack/
weight without cord
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
Alternating current
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Electromagnetic disturbances:
In individual cases, the speed may fluctuate tempo-
rarily if the machine is exposed to extreme external
electromagnetic disturbances or the electronic
restart protection may respond. In this case, switch
the machine off and on again.
Emission values
Using these values, you can estimate the
emissions from this power tool and compare these
with the values emitted by other power tools. The
actual values may be higher or lower, depending on
the particular application and the condition of the
tool or power tool. In estimating the values, you
should also include work breaks and periods of low
use. Based on the estimated emission values,
specify protective measures for the user - for
example, any organisational steps that must be put
in place.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value
h, SG
(surface grinding)
a = Vibration emission value
h, DS
(disc sanding)
K = Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels::
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
ENGLISH en
19