Selecting The Operation Function; Cooling - BALAY 3XM4H Serie Instrucciones De Uso

Instructions for Use

Selecting the operation function

The following functions can be selected on
your appliance:

• cooling

.
• dehumidification .
• air purification
.
Place the selection box on the operation
function menu using the "up" and "down"
keys (see "Navigation": "up" and "down"
keys).
Use the "+" and "–" keys to move within the
selection box and select the desired function
(see "Navigation": "+" and "–" keys).
Cooling
In this function the appliance reduces
ambient temperature until the desired
temperature is reached. The appliance
dehumidifies and purifies the air in the
room at the same time in order to create a
pleasant atmosphere.
• Plug the appliance into the mains
electricity supply.
• Lead the hot air expulsion tube outside,
(see "Preparing the appliance before use").
• Check that the plug is fitted onto the
water drainage pipe to prevent water
from leaking onto the support surface.
• Lift the air director on the top of the
appliance, Fig. 17.
Fig. 17
• Turn the appliance on by pressing the
"On" key .
• Select the cooling function
"Selecting the operation function").
• Select the desired temperature, (see
"Selecting the temperature"). If the
appliance turns itself off automatically
because the desired temperature for the
room has been reached, it will not start
working again until ambient temperature
rises 2-3°C.
• Select the operation speed, (see
"Selecting the speed").
During air conditioning, the condensed
water produced evaporates automatically
and is expelled outdoors together with the
expelled air through the hot air expulsion
tube.
In conditions of extreme humidity, the
appliance accumulates condensed water
in the appliance's rear tank. When a
certain level is reached,
beeps twice. At the same time
symbol appears on the screen to
indicate that the tank needs to be
emptied. The appliance stops working
when this happens. To empty the
removable tank, press the handle and
remove the tank carefully. Empty the water
down the nearest drain.
The symbol disappears from the screen
when the water tank has been emptied
and replaced on the appliance properly.
Warning!
When you turn the appliance back on
again after emptying all of the water, do
not forget to replace the removable
tank on the appliance properly. Should
you fail to do so, the symbol will not
disappear from the screen and the
appliance will not work.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before the
compressor starts up again. This period
of time is required in order to ensure
correct appliance operation.
57
, (see
the appliance
ank full