Silhouette curio Manual De Instrucciones página 57

Inserting the Base into the Curio
Before inserting the base into the Curio, it is important to
ensure there is adequate clearance in front of and
behind the Curio for the base to move in and out
unimpeded. You can also extend the stabilizing feet
for additional stability of heavy or long projects.
To load the base into the Curio:
1. Power off the Silhouette Curio
2. Insert the base into the front of the Curio
3. Push the base inward until the leading edge of
the base extends out the back of the Curio
4. Power on the Curio
Prepare the blade plunger by removing the protective covering and adjusting the blade to the
appropriate number setting for the material you plan to cut. Refer to Silhouette Studio® for
recommended blade settings for different materials.
Blade setting Material
1 Thin materials such as vinyl and smooth heat transfer material
2-3 Medium-weight materials such as paper, cardstock and flocked heat transfer material
4-6 Thicker materials such as textured cardstock and pattern papers
7-10 Thick materials such as canvas
To adjust the blade setting, place the grey ratchet cap on the end of the blade so the arrow on the cap
lines up with the red line on the blade. Turn the ratchet to the desired number.
ratchet cap
NOTE: To remove fibers from blade housing, ratchet blade down to 0 and carefully grasp the
white tip turning it counterclockwise to remove the small end cap. Blow fibers away (do not
touch blade). Replace and hand-tighten cap.
9
Getting Started with Silhouette Curio™
numbered blade setting
blade