Maintenance Instructions; Troubleshooting Guide - BriskHeat Custom Serie Manual De Instrucciones

MAINTENANCE INSTRUCTIONS

Anyone who reads and understands these instructions
is qualified to maintain this heater.
Maintenance:

All maintenance should be performed after heater has cooled to room temperature and with
the electricity disconnected.

This product should be inspected prior to being installed and at least every 3 months during
use.

Dirt, oil, grease or other foreign matter can be removed with a damp rag and mild household
cleaners.

Do not attempt to repair a damaged heater.
Inspection:

Inspection should be performed after the heater has cooled to room temperature and with
the electricity disconnected.

The heater should be free of any cuts, cracks, or punctures.

The power leads should not have any visible breaks in their insulation

The heater should be free of any build-up of dirt, oil, grease, or other foreign matter.
Storage:

This product should be stored indoors.
Disposal:

This product does not contain any hazardous substances and may be discarded with
domestic waste.
®
© BriskHeat Corporation. All rights reserved
SRL5, SR, SRV, FGH, and SXH
Composite Curing Blankets
.
9

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting BriskHeat
commonly asked questions. If you are unable to identify the problem or need additional
assistance, please contact your local distributor/ representative or us at 1-800-848-7673,
614-294-3376, or bhtsales1@briskheat.com.
PROBLEM SOLUTION(S)
Does not heat Verify heater is connected to proper voltage. The identification label
located on the power cord displays the heater's voltage requirement.
Using an ohm meter, check to see if there is a resistance
reading (not an open circuit) in the heater.
If external temperature controlling device is installed, ensure the heaters
control dial is in the maximum heating position.
Circuit breaker is Validate that the circuit breaker is capable of handling the amp
tripping requirement of heater. The identification label located on the power cord
displays the heater's amperage requirement.
Examine the heater and the power cord for any damage.
®
© BriskHeat Corporation. All rights reserved
SRL5, SR, SRV, FGH, and SXH
Composite Curing Blankets
®
. This guide is designed to answer the most
.
10