How To Use - Koshin Mister AUTO HS-W Serie Manual De Instrucciones

EN
Attach belt to body.
How to lace belt in
Attention to buckle direction
Pay attention to buckle direction
when attaching belt. Belt would not
be fixed with wrong buckle direction.
- Insert buckle in belt attaching
part. Place buckle so that edge
of folded belt faces outside.
Assemble nozzle.
Packing
Nozzle body
Caution
Make sure that packing is preset on connection part.
Tighten up well so no leakage.
Pull pump out.
1. Rotate change cap until
mark comes to (Fix).
(Fix)
Rotate change cap.
Pull pump out while rotating handle.
(Counter clockwise)

How to Use

Pour chemical into tank.
- Dissolve chemical sufficiently in a separate container before
pouring into tank.
Completely dissolve.
Any chemical added
must be completely
dissolved.
*Container is not included in set.
Be sure that no previously used chemical has been left
Belt
in tank. If so, chemical reaction may occur generating
attaching part
harmful gas.
Do not exceed specified quantity.
To combine
This would shorten spraying duration.
(Specified quantity : 5L tank: 5th scale, 7L tank: 7th scale)
To
Water
Nozzle
detach
(L)
1
4
5
7
2. Rotate handle to pull
pump out.
To remove
Restore pump to original position before pressurizing.
To attach
Do not pressurize when nozzle is in nozzle stand.
This may cause injury.
Make sure that nozzle lever is not set for spraying before
applying pressure to prevent erroneous function.
Caution
Caution
Chemical (cc)
×500 ×1000 ×2000
2 1 0.5
8 4 2
10 5 2.5
14 7 3.5
Scale unit of syringe: cc
(cc = g = ml)
Warning
Caution
1. Place pump in tank.
2. Rotate change cap to align
mark to (Quick).
Move handle upward and
downward to apply pressure
into tank.
Precaution in changing.
Push handle down to the
lowest position to operate
change cap.
3. If you feel heavy while pressurizing,
rotate change cap until mark
places at (Light ). This would
enable to pressurize with light force.
Rotate
(Light )
change cap.
Indicator for pressurizing
Scale around safety valve indicates pressure
level inside tank. Apply pressure until scale
positions 5 or 0.5Mpa or according to specified
quantity of tank. Such level pressure is unnecessary if
smaller amount chemical is used. (Appropriate spraying
is assured if scale indicates 1(0.1Mpa) or larger.)
This scale just serves as indicator and could slightly
deviate from actual pressure level.
4. Stop pressurizing when safety valve pops air. This means
appropriate pressure has been obtained for spraying.
Safety Valve
Set for preventing breakage due to overpressure,
this automatically lets excess pressure out when
appropriate pressure is reached.
5. Lock handle after applying pressure.
(Quick)
Rotate
change cap.
Pressurizing