Important Installation I Nstructions - Genie CHAINLIFT 1022 Manual De Instrucciones

IMPORTANT INSTALLATION I NSTRUCTIONS
1. READAND FOLLOW ALL SAFETY, INSTALLATION 5.
AND OPERATION INSTRUCTIONS. (/yo haw;_
,_;i _;;_,_ _ :_' _,_'_d _ _/_ _/'_ 6.
2. Install only on a properly balanced sectional garage door.
An improperly balanced door could cause severe injury.
Have a trained door system technician make repairs or
adjustments to cables, spring assemblies, and other 7.
hardware before installing the opener.
3. Removeall ropesand remove or make inoperativeall
locks connectedto the garage door before installingopener.
4. Where possible,installthe door opener 7 feet or more 8.
above the floor. For productshavingan emergency
release,mount the emergencyrelease6 feet above the floor.
Do NOT connect the opener to source of power
until instructed to do so.
Locate the control button:
• Within sight of door,
• At minimum height of 5 feet so small children are not
able to reach it, and
• Away from all moving parts of the door,
Install the Entrapment WARNING Label next to the
control button in a prominent location, Install the
Emergency Release Tag on or next to the
emergency release,
After installing the opener, the door must reverse within
2 seconds when it contacts a 1-1/2 inch high object (or a
2 x 4 board laid fiat) on the floor,
I
To reduce the risk of injury to persons or
damage to property - Use this opener only
with sectional doors.
I
Do NOT run until opener is fully assembled.
Clear a workspace area to unpack and organize box
and contents for assembly.
1. There are 4 boxes inside the carton. Each box is
numbered 1 - 4. Note that some openers will
contain the same parts and be packaged with
fewer boxes. Carefully remove the three
internal boxes (Labeled #1, 2, and 3) and place
them on the floor for easy access (Fig. 1-1).
These boxes contain assembly parts and the
contents are organized by assembly tasks For
quick reference inside the id of each box there is
a label illustrating the components inside.
2. Remove the motor power head and place it on
the floor for later use. Remove box #4 and
place it on the floor for later use.
Bag 0
Bag 1
Bag 2 .............
Header _rac_et --- _
Bag 3 __i'
Box Label Example
FIG. 1-1 Internal boxes.
PN# 36420Supplement, 10/27/2008 9