Transport, Assembly, Putting Into Operation And Decommissioning; Transport; Assembly (Built-In Appliances Only); Unheated Appliances (Ebr/V19-26 | Ebr/V27-33) - Hupfer TE-2/V19-26 Manual De Instrucciones

Chapter 4
Page 20
4 Transport, Assembly, Putting into Operation and Decommis-
sioning
4.1

Transport

ATTENTION
4.2

Assembly (Built-in appliances only)

The following section describes the assembly of the built-in plate dispenser.
Primarily, the unheated appliances EBR/V19-26 and EBR/V27-33 are described that do not require any elec-
trical installations after the assembly.
Subsequently, there follows the assembly description of the heated appliances EBRH/V19-26, EBRH/V27-33
and EBRH-2/19-26 that must be connected to the power supply after the assembly.
4.2.1

Unheated appliances (EBR/V19-26 | EBR/V27-33)

NOTE
Figure 4
Plate dispenser
TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26

Transport, Assembly, Putting into Operation and Decommissioning

Appliance damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly. The total brakes are not sufficient as a transport
securing method.
If the appliances are not secured properly, there is a risk of damage to prop-
erty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Appliance location
Built-in appliances may only be used after being retrofitted or built-in (e.g. in a
cabinet).
Worktop cut-out EBR/V19-26
Transport
4330000_A3