Heated Appliances (Ebrh/V19-26 | Ebrh/V27-33 | Ebrh-2/19-26) - Hupfer TE-2/V19-26 Manual De Instrucciones

Chapter 4
Page 22
EBR/V27-33
§
Insert the appliance EBR/V27-33 into the worktop cut-out from above and fasten it.
Figure 7
4.2.2

Heated appliances (EBRH/V19-26 | EBRH/V27-33 | EBRH-2/19-26)

DANGER
ATTENTION
NOTE
There is a lead set with a wiring diagram attached to the built-in heated appliances.
The set consists of a lead with a Schuko® plug and a lead with a mains plug fitted on the appliance. The
leads are wired up with the on/off switch with an integrated indicator light.
Plate dispenser
TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26
Transport, Assembly, Putting into Operation and Decommissioning
Assembly instructions EBR/V27-33
Hazardous electrical voltage
The electrical voltage may be considerably dangerous to limb and life of per-
sons and lead to injuries.
All work on the electrical installations should only be carried out by a certified
electrician or by authorised specialists under supervision and monitoring of a
certified electrician according to the applicable electro-technical regulations.
Risk of hot surfaces
The internal surfaces and base plates of the heated appliances can become
hot during and/or after the operation. The heated appliances should not come
into contact with light inflammable materials.
Ensure that there is enough space between the housing and cladding re-
quired for air circulation.
Appliance location
The built-in appliances may only be put into operation after being retrofitted or
built-in (e.g. in a cabinet).
Assembly (Built-in appliances only)
4330000_A6