Connect Wiring - NuTone ALLURE WS15 Serie Manual De Uso

PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
11 Remove appropriate Duct Knockout(s) from top or back of
hood.
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
3¼" x 10" Ducted Discharge Only: Attach Damper/Duct
12
Connector over knockout opening. Make sure damper Pivot
is nearest to Top/Back Edge of hood. Remove Tape from
damper flap.
13 7" Round Ducted Discharge Only: Re-install 7" Round Duct
Plate removed in Step #1 under "PREPARE THE HOOD"
section. Install a 7" round damper (purchase separately).
Damper flap must open freely in direction of air flow (away
from range hood).
To accomodate off-center ductwork, the Damper/Duct
NOTE
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to ½" on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)
TOP/BACK
TAPE
EDGE
DAMPER/DUCT
CONNECTOR
(Vertical discharge
position shown)

CONNECT WIRING

WARNING: To reduce the risk of electric shock,
make sure power is switched off at the service
panel. Lock or tag service panel to prevent power
from being switched on accidentally.
Connect House Wiring (120 VAC) to hood. Use a piece of
1
Cardboard to protect the cooktop, if necessary.
2 Connect house black to hood black wire, house white to hood
white wire, and house ground under Green Ground Screw.
Securely tighten cable clamp onto house wiring.
3 Replace wiring cover.
ALLURE™ WS15 SERIES
RANGE HOOD
HOUSE
WIRING
(120 VAC)
CARDBOARD
(Use to protect
cooktop)
Page 4
GREEN
GROUND
SCREW