Replacing Brushes - Panasonic MC-GG525 Instrucciones De Operación

E-Clip
Bride en E
Sujetador
de E
Agitator Shaft
Abre d'entraînement
Eje del agitador
Agitator Pulley
Poulie de l'agitateur
Polea del agitador
Push Off
Pousser
Enpuje hacia fuera

Replacing Brushes

Card
Carte
Tarjeta
Right End Cap
Bouchon droit
Tapa del extremo
derecho
Agitator Support
Support de l'agitateur
Soporte del agitador
Brush
Brosse
Cepillo
➢ When the bristles on the agitator are
worn so that they do not touch a
card held across the lower plate, the
brushes should be replaced.
➢ Remove lower plate and agitator.
➢ Remove the E-clip from agitator
shaft and end cap.
➢ Do not bend agitator shaft or lose E-
clip or spacer.
➢ Pull agitator shaft out of agitator
body.
➢ Pull, or pry out, agitator holder and
agitator pulley.
➢ Push each brush out of agitator
body as shown.
➢ Install new brushes by reversing
procedure.
➢ Reinstall agitator holder and agitator
pulley completely.
➢ Reinstall the agitator shaft, end cap
and E-clip.
➢ See exploded view for correct
assembly of parts.
➢ Position belt over agitator pulley on
the agitator.
➢ Reinstall agitator and lower plate.
- 42 -