CommScope 43094 Instrucciones De Instalación página 4

Bulletin 17262G, Revision M, page 4 of 24
5 Tightly twist the lacing together several times at the end of the
seam as shown in Figure 5a. Wrap the lace around the hoisting
grip, twist it together, and thread the remainder of lace through
grip as shown in Figure 5b. Do not tie knots with the lace because
they will not hold!
5a
6 IMPORTANT: First, remove the tape from the tip of the hoisting
grip. Then, place both hands firmly around the bottom of the
grip and slide them upward to the top as shown in Figure 6. This
pulling action removes slack throughout the grip. Repeat this twice.
6
CommScope
1100 CommScope Place SE P.O. Box 339, Hickory, NC 28603-0339
(828) 324-2200 (800) 982-1708
www.commscope.com/andrew
Notice: CommScope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: CommScope no acepta ninguna obligación ni responsabilidad como resultado de prácticas incorrectas o peligrosas de instalación, inspección, mantenimiento o retiro.
Avis : CommScope décline toute responsabilité pour les conséquences de procédures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: CommScope lehnt jede Haftung oder Verantwortung für Schäden ab, die aufgrund unsachgemäßer Installation, Überprüfung, Wartung oder Demontage auftreten.
Atenção: A CommScope abdica do direito de toda responsabilidade pelos resultados de práticas inadequadas e sem segurança de instalação, inspeção, manutenção ou remoção.
Avvertenza: CommScope declina eventuali responsabilità derivanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
© 2013 CommScope Bulletin 7543369
5b
7 Attach the hoist line to the grip as shown in Figure 7. Tie the
cable or waveguide leader to the hoist line so that the leader
does not dangle. Apply tension slowly to the hoist line to allow the
hoisting grip to tighten uniformly on the cable or waveguide.
7
Hoist-line pulley
Antenna connector
Rope tie
Cable or
waveguide
leader
Rope
tie
Hoisting
grip
Maintain tension on the hoisting grip during hoisting. Loss
of tension can cause dangerous movement of the cable or
waveguide and result in injury or death to you or others on or
near the tower. Also, do not release tension on the grip until
after the cable or waveguide has been fastened to the tower
members.
Customer Service 24 hours
North America: +1-800-255-1479 (toll free)
Any country: +1-779-435-6500
email: acicustomersupportcenter@commscope.com
Ground wire
attachment
Hoist
line
WARNING