Activity Camera Setup - Dedicated Micros Eco9 Guía De Programación

Contrast adjust
When the contrast bar is selected, press down to reduce, and up to increase
the contrast.
Camera video input
This option is only displayed when a camera has failed or is offline. Select
disconnect whilst the camera is offline to prevent the camera fail message and
alarm being triggered.
Tip: This menu can be entered directly by pressing and holding a camera key.

Activity Camera Setup

Activity detection is used to record more images to disk from cameras that
have activity. The sensitivity of activity can be adjusted and areas can be
masked off according to the scene type.
Detection
Select whether activity detection is on or off for the selected camera.
Sensitivity
There are 5 levels of sensitivity for activity detection to ensure any scene
environment can be covered.
Note: When setting the sensitivity it is recommended that the Activity test
option be utilised to ensure the correct sensitivity is selected.
Select the sensitivity level which matches the camera's placing:
Cameras sited outdoors where there may be a lot of background
•
movement, such as trees or rain, should be set to Outdoor high, Outdoor
low sensitivity or very low sensitivity.
Cameras sited indoors where there is very little background movement
•
should be set to Indoor high or Indoor low.
The sensitivity levels:
Indoor High (most sensitive setting)
•
Indoor Low
•
Outdoor High
•
Outdoor Low
•
Very Low (lowest sensitivity level)
•
21