Specific Safety Instructions; Before Use; Connecting To A Compressed Air Source - Parkside PDRP 6.2 B2 Traducción De Instrucciones Originales

■ Keep work area clean and well lit . Cluttered or
dark areas invite accidents . This enables better
control of the compressed air cleaning gun,
especially in unexpected situations .
■ Have the compressed air cleaning gun serviced
by a qualified repair technician using only
original replacement parts . This ensures that the
safety of the compressed air cleaning gun is
maintained .
■ Keep children and bystanders away while
operating the compressed air cleaning gun .
Distractions can cause you to lose control of the
compressed air cleaning gun .
■ Dress properly . Do not wear loose clothing or
jewellery . Keep your hair, clothing and gloves
away from moving parts . Loose clothes, jewel-
lery or long hair can be caught in moving parts .
■ Wherever possible, use a condensate separator
or drain the condensate (water) from the hoses
and tubing regularly before and during the use
of the compressed air cleaning gun .
NOTE!
► An undersized compressed air system will
reduce the efficiency of your compressed air
cleaning gun .
■ Do not point the compressed air cleaning gun
at people or animals .

Specific safety instructions

■ Do not use force when operating the trigger
■ Make sure that all parts are securely mounted
before using the compressed air cleaning gun .
■ Wear the necessary protective clothing when
working with the compressed air cleaning gun,
in particular ear muffs, protective goggles and
work gloves .
■ 36 │ GB │ MT

Before use

NOTE
► The appliance may only be operated with
cleaned compressed air and may not exceed
the maximum working pressure of 6 .2 bar
at the appliance . The compressor must be
fitted with a pressure reducer to regulate the
working pressure .
► Note that the maximum working pressure
may not be exceeded . An excessive working
pressure does not mean increased output;
it merely increases the air consumption and
accelerates appliance wear . Always comply
with the technical information .
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source,
–
the correct working pressure (3–6 .2 bar)
must be fully reached, and
–
make sure that the trigger
♦ Pull the supply hose connector over the quick-
release fastener on the connector nipple
it clicks into place .
NOTE
►
To ensure that you can regulate the air
pressure, the compressed air source must be
.
equipped with a pressure reducer .
is not actuated .
until
PDRP 6.2 B2